Each version is available for 5 different flow ranges: - model QN 0.6 DN15: 0.06 to 20 l/min (nominal flow rate 0.6 m3/h namely 10 l/min) - model QN 1.5 DN15: 0.1 to 50 l/min (nominal flow rate 1.5 m3/h namely 25 l/min) - model QN 2.5 DN20: 0.16 to 82 l/min (nominal flow rate 2.5 m3/h namely 41 l/min) - model QN 3.5 DN25: 0.6 to 116 l/min (nominal flow rate 3.5 m3/h namely 58 l/min) - model QN 6.0 DN25: 1 to 200 l/min (nominal flow rate 6. Find the ideal flowmeter for your application and compare different models, features and advantages. The flowmeter features, depending on the version: - a pulse output or - a pulse output and a 4…20 mA current output. Brkert offers a wide range of flowmeters for liquids, gases and solids, such as Coriolis, electromagnetic, paddle wheel, oval gear, ultrasonic, switch/flow, rotameter and FLOWave. The electrical connection is made via a 5 pin M12 fixed connector. In combination with a controller and a control valve, it enables very simple flow control loops to be established. It consists of an electronic module and a brass fitting with a built-in measuring tube. Type 8701 can optionally be calibrated for two different gases the user can switch between these two gases. The thermal MEMS sensor is located directly in the gas stream and therefore reaches very fast response times. *For selecting thecorrect product please refer to the technical data, images and notes for proper use according to the data sheet, or contact Flu-Tech directly.The Type 8081 ultrasonic flowmeter is intended for the flow measurement of water which may be slightly charged with contaminants. The mass flow meter (MFM) type 8701 is suited for measuring the mass flow of gases over a big flow range. Indoorandoutdoor(protectthedeviceagainstelectromagneticinterference,ultravioletrays andagainsttheeffectsofclimaticconditions) The applied standards, which verify conformity with the EU Directives, can be found on the EU Type Examination Certificate and/or the EU Declaration of conformity (if applicable).Ĭomplying with Article 4, Paragraph 1 of 2014/68/EU directiveĭetailed information on the pressure equipment directive can be found in chapter “3.2. The flowmeters have high accuracy, rapid start-up and suitability for aggressive liquids. IP65 under the following conditions: device wired, cover and lid screwed tight and cable plug or glands mounted and tightened or with blind plug if not used Brkert offers insertion and inline paddle wheel flowmeters for low and high flow rates, neutral, mildly aggressive and solid-free liquids. Plastic: true union with nut and solvent/fusion socket, spigot or external thread See data sheet Type S030 for more information.ĭegree of protection2.) accord-ing to IEC/EN 60529.Metal: Internal or external thread, weld ends, clamp or flange.PN 16 (PN 40 on request) with metal sensor-fittingĭetailed information can be found in the data sheet of the Inline sensor-fittings, see data sheet Type S030 for more information.PVDF, stainless steel or brass: – 15…+ 100 ☌ (+ 5…+ 212 ☏) See data sheet Type S030 for more information.Cable with maximum operating temperature greater than 80 ☌ (176 ☏) (90 ☌ (194 ☏) for UL-Recognized version).Limited power source according to UL/EN 60950-1 standards or limited energy circuit according to UL/EN 61010-1 §9.4 Standard K-factor: ± 2.5 % of the measured value1.). Teach-In: ± 1 % of the measured value1.) at Teach-In flow rate value.Dimensions” on page 12.ġ5 × 60 mm, 8-digit LCD, alphanumeric,15 segments, 9 mm highĪny pipe from DN 06…DN 65 which is fitted with Bürkert S030 Inline sensor-fitting.įor the selection of the nominal diameter of the Inline sensor-fittings, see data sheet Type S030. General Technical Data Product propertiesīrass, stainless steel, PVC, PP or PVDF (depending on S030 version)ĭetailed information can be found in chapter “5. Burkert - Type 8644 - AirLINE Remote Process Actuation Control System.Optional, four different gases can be calibrated. Type 8745 can be configured as MFM or MFC. Burkert - Type 8802 - Continuous control Valve Systems Overview (Type ELEMENT) 20048636 - The mass flow controller (MFC) / meter (MFM) Type 8745 is suitable for mass flow control of high flow rates.Burkert - Type 8619 multiCELL Multi Channel and Multi Function Transmitter / Controller.Burkert - Type 8611 - eCONTROL Universal Controller.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |